Interface revisions for HALCON 9/10 software
Go to MVTec
MVTec releases revised image acquisition interfaces
HALCON 9/10 MultiCam Interface
Revision 4.4 of HALCON 9.0 / 10 MultiCam interface now supports DOMINO
Symphony boards and also GRABLINK Full boards in combination with 10-tap
devices. This interface is based on the Euresys MultiCam driver
and supports the DOMINO Iota/Alpha/Gamma/Delta, the DOMINO Melody/Harmony/Symphony,
the GRABLINK Value/Avenue/Expert/Express and PICOLO frame grabber boards.
HALCON 9/10 Pylon Interface
Rvision 4.12 of HALCON 9.0 / 10 Pylon
interface which allows limiting the device discovery to a certain transport
layer technology like GigE Vision or IIDC 1394 which improves camera
connection time. This is the image acquisition Interface for Basler
GigE Vision and IEEE 1394 cameras via pylon library
HALCON 9/10 Sapera LT Interface
Revision 4.11 of the HALCON 9.0 / 10
Sapera LT interface fixes a problem with delay and duration parameters
with some frame grabber boards, where valid values could not be set.
The HALCON Sapera LT interface is for analog and digital frame grabber
boards like Xcelera-CL, X64-CL, X64-AN Quad, and PC2-Vision, and also
the Genie GigE Vision camera series from Teledyne DALSA.
Please contact
Adept Turnkey for a download details for
any of the above revisions
adept@adept.net.au
|
Adept Turnkey Pty Ltd are 'The Machine Vision and
Imaging Specialists and distributor for MVTec products in Australia
and New Zealand. To find out more about the MVTecproducts, please
email us at: adept@adept.net.au,
call us at Perth (08) 92425411 / Sydney (02) 99792599 / Melbourne
(03) 95555621 or use our online contact
us form. |
|
|