MVTec
make camera calibration easier
Go to MVTec
Go to Machine vision
software
Go to Halcon 12
Accurate
camera calibration, 3D positioning and orientation
Camera calibration is a critical task for obtaining accurate real-world
measurements in machine vision applications.
With the release of HALCON 12, MVTec introduces
a new, redesigned calibration target that eases
the process significantly.
New plate's benefits
•
|
More
calibration marks providing better radial lens distortion
correction with fewer images |
• |
multiple
unique finder patterns embedded within the hexagonal mark
array |
• |
Because
only one finder pattern needs to be visible in the image for
calibration, the entire field of view can be covered with
calibration marks |
• |
Fewer images needed for 3D calibration while
giving same level
of accuracy as the old method |
|
|
Additonal
benefits
Having multiple unique finder patterns allows
images from multiple cameras observing different portions of the
same plate to be mapped into the same world coordinate system. This
enables the performing of calibrated image stitching without the
need for a custom fixture to hold several targets at precisely-known
distances. The new calibration targets are offered
in several different sizes ranging from 20mm x 15mm up to 320mm
x 240mm.
HALCON 12 continues to support the old calibration target, and
as with previous versions of HALCON, it is still possible to print
your own plates for testing purposes. Printed targets should not
be used for high-accuracy applications, however.
|
|
|
|
Adept Turnkey Pty Ltd are "The Machine Vision and Imaging Specialists"
and distributor of MVTec products in Australia and New Zealand. To find
out more about MVTec's products or any machine vision product, please
contact us
or call Perth (08) 9242 5411 / Sydney (02) 9905 5551 / Melbourne (03)
9384 1775
|